How to find a water leak under concrete

To find a leak under a concrete slab, run a meter test, then close the cold inlet at the water heater to see if the leak is on the hot or cold side. Pros then pinpoint it with acoustic, electronic and thermal tools, so concrete is cut only at the exact spot.
Step 1: confirm there is a leak
Do the meter test. If the meter does not move, your problem may be a faucet, toilet or a billing issue rather than a slab leak.
Step 2: narrow it down
- Close the main shutoff at the house. If the meter keeps moving, the leak is outside (see main water line leaks).
- If the meter stops, open the main again.
- Close the cold-water inlet at the water heater and see whether the meter slows or stops. If it does, the leak is on the hot-water side.
- Walk the house and feel the floor for warm spots (warm spot on floor).
- Listen at fixtures and floors for hissing or running water.
What not to do
- Do not break concrete based on a guess
- Do not rely on sealants or drain cleaners for pressurized supply lines
- Do not ignore a moving meter
How professionals pinpoint the leak
| Method | What it does |
|---|---|
| Pressure test | Shows which line loses pressure |
| Acoustic listening | Hears escaping water through the slab |
| Correlator and tracer gas | Calculates leak position, finds quiet leaks |
| Thermal imaging | Shows warm patterns above hot-water leaks |
We cross-check with a second method before marking the leak. Learn more about slab leak detection and electronic leak detection.
Related help
- Warm Spot on Floor: Slab Leak?
- Water Meter Running With Everything Off
- Emergency slab leak checklist
- Slab leak detection
Frequently asked questions
Can I find a slab leak myself?
You can confirm a leak and narrow it to hot or cold, but pinpointing it under concrete usually needs professional equipment.
How do I know if the leak is hot or cold water?
Close the cold inlet at the water heater and watch the meter. If it slows or stops, the hot side is leaking.
Do I need to break the slab?
Not until the leak is located. Detection tools mark the exact spot first.
How long does finding a slab leak take?
Most inspections take one to three hours.